[Olsr-users] [Olsr-dev] olsrd 0.6.6.1 (and earlier) ipv6 problems
Sat Mar 29 15:20:35 CET 2014
Still we should look into the problem with the fragmentation anyways.
On Sat, Mar 29, 2014 at 3:18 PM, Teco Boot <(spam-protected)> wrote:
> What I have *is* dynamic.
> What is missing in OpenVPN: float. With float, the tunnel doesn't depend on
> smartgateway or whatever, the tunnel would survive changing attachment
> points. Float is in 2.4 (I hope).
> Op 29 mrt. 2014, om 07:33 heeft Russell Senior <(spam-protected)>
> het volgende geschreven:
> We could switch to a static routing regime, but olsr is (has been) nice for
> handling it all dynamically for us.
> Is this limitation in olsr we have encountered correctable in the near term,
> or should we be looking at converting to static routes?
> On Fri, Mar 28, 2014 at 9:58 AM, Teco Boot <(spam-protected)> wrote:
>> Running a MANET protocol over a VPN hub&spoke infrastructure is not
>> something I recommend. On hub, all TC messages are pushed on all tunnels.
>> Can introduce problems when packet rate isn't shaped.
>> What we have is a VPN tunnel for each OLSR router. On spokes, RFC1918
>> routes go into the tunnel. Hub has /24 routes back, generated from
>> certificate. Scales very well.
>> Op 28 mrt. 2014, om 14:54 heeft Ferry Huberts <(spam-protected)> het
>> volgende geschreven:
>> > On 28/03/14 10:34, Henning Rogge wrote:
>> >> Hi,
>> >> I must admit that I am not convinced that its an Olsrd bug what we are
>> >> seeing...
>> >> If I see it correctly Olsrd is running over the VPN interface
>> >> connection (interface name "vpn"), right?
>> >> Is the VPN connection between the nodes still active during the route
>> >> loss? Most of the nodes seem to have direct connections and the "30
>> >> seconds until recovery" sounds like an ETX value slowly going down and
>> >> then dropping the link.
>> > 30 seconds is also something we see when our vpn connections break...
>> > --
>> > Olsr-users mailing list
>> > (spam-protected)
>> > https://lists.olsr.org/mailman/listinfo/olsr-users
> Olsr-dev mailing list
More information about the Olsr-users