[Olsr-users] Fwd: Configuring two nodes directly (without a gateway) - OLSR.
Thu Sep 5 13:42:46 CEST 2013
do you have already checked that you have direct IP connectivity? Can
you ping the other node over the network?
If you only have two nodes, ping will work with or without OLSR, because
you can only communicate with 1-hop neighbors without routing protocol.
If you cannot ping the other node, then you have trouble on layer-2
(wifi) or with your interface configuration.
On 09/05/2013 01:36 PM, Shyam B wrote:
> Hi Al,
> I am configuring _multiple RaspberryPI's_ as nodes in a mesh network. I
> don't plan to use routers as gateway. Having installed OLSR on these
> nodes (currently two to begin with), I am unable to communicate between
> The configuration was working with the routers.
> _What I did_
> Exactly same setup on the two nodes:
> Ad-Hoc mode, Channel 10 with same ESSID.
> Tried to change hna, Ip4Broadcast to the same subnetwork as well.
> Nothing works!
> The iwconfig screenshot and olsrd.conf file attached. I have spent
> multiple hours trying to get it to work!!
> It would be of real help if someone can point out if communication
> between two raw nodes is selected. If not why not, and what do I have to
> do to make this setup work. Eagerly looking forward!
Diplom-Informatiker Henning Rogge , Fraunhofer-Institut für
Kommunikation, Informationsverarbeitung und Ergonomie FKIE
Fraunhofer Straße 20, 53343 Wachtberg, Germany
Telefon +49 228 9435-961, Fax +49 228 9435 685
-------------- next part --------------
A non-text attachment was scrubbed...
Size: 6169 bytes
Desc: S/MIME Cryptographic Signature
More information about the Olsr-users