[Olsr-dev] OLSRv2 configuration and wlan

[Karoly Szabo]

Of course:

1: lo: <LOOPBACK,UP,LOWER_UP> mtu 65536 qdisc noqueue state UNKNOWN
    link/loopback 00:00:00:00:00:00 brd 00:00:00:00:00:00
    inet 127.0.0.1/8 scope host lo
    inet6 ::1/128 scope host
       valid_lft forever preferred_lft forever
2: eth0: <BROADCAST,MULTICAST,UP,LOWER_UP> mtu 1500 qdisc mq state UP qlen
1000
    link/ether 00:18:8b:1b:7e:59 brd ff:ff:ff:ff:ff:ff
    inet 147.162.97.20/24 brd 147.162.97.255 scope global eth0
    inet6 fe80::218:8bff:fe1b:7e59/64 scope link
       valid_lft forever preferred_lft forever
3: eth1: <NO-CARRIER,BROADCAST,MULTICAST,UP> mtu 1500 qdisc pfifo_fast
state DOWN qlen 1000
    link/ether 00:50:da:45:4c:d4 brd ff:ff:ff:ff:ff:ff
4: wlan1: <NO-CARRIER,BROADCAST,MULTICAST,UP,LOWER_UP> mtu 1500 qdisc mq
state DORMANT qlen 1000
    link/ether 00:1d:7d:49:2b:e9 brd ff:ff:ff:ff:ff:ff
    inet 192.168.1.220/24 brd 192.168.1.255 scope global wlan1
    inet6 fe80::21d:7dff:fe49:2be9/64 scope link
       valid_lft forever preferred_lft forever

iwconfig (same cell on the other node of the network):

wlan1     IEEE 802.11bg  ESSID:"MILCOM2013"
          Mode:Ad-Hoc  Frequency:2.412 GHz  Cell: 56:1B:37:92:E2:63
          Tx-Power=20 dBm
          Retry  long limit:7   RTS thr:off   Fragment thr:off
          Encryption key:off
          Power Management:off




2013/11/12 Henning Rogge <(spam-protected)>

> Can you just post the raw output of "iwconfig wlan1" and "ip addr"?
>
> Getting no interface address on wlan1 is very strange, you should at
> least have an IPv6 linklocal address!
>
> Henning Rogge
>
> On Tue, Nov 12, 2013 at 5:56 PM, Karoly Szabo <(spam-protected)>
> wrote:
> > Hi,
> > the ip remains the same:
> > eth0: 147.162.97.20
> > wlan1:  192.168.1.120
> > lo: 127.0.0.1
> >
> > also the result for
> > nhdp iflink:
> >
> > Interface 'eth0': hello_interval=2   hello_vtime=20
> >     Address: 147.162.97.20
> >     Address: fe80::218:8bff:fe1b:7e59
> >     Link: status=symmetric localif=eth0 vtime=38.756   heard=18.756
> > symmetric=18.656   dualstack
> >         Originator: 147.162.97.9
> >         Link addresses: 147.162.97.9
> >     Link: status=symmetric localif=eth0 vtime=38.756   heard=18.756
> > symmetric=18.656   dualstack
> >         Link addresses: fe80::f24d:a2ff:fe37:cbd8
> >
> > Interface 'lo': hello_interval=2   hello_vtime=20
> > Interface 'wlan1': hello_interval=2   hello_vtime=20
> >
> > Similar results came from the machine with ip: 147.162.97.9
> >
> > It seems that the Wifi interfaces does not initialize themselves in Olsr.
> >
> > Regards,
> > Karoly
> >
> >
> >
> > 2013/11/6 Henning Rogge <(spam-protected)>
> >>
> >> Hi,
> >>
> >> what IP addresses have you set on eth0, wlan1 and lo before (and
> >> after) you run olsrd2 ?
> >>
> >> maybe you can run "ip addr" twice, once before you start the routing
> >> daemon and once 30 seconds afterwards.
> >>
> >> Henning Rogge
> >>
> >> On Wed, Nov 6, 2013 at 7:56 PM, Karoly Szabo <(spam-protected)>
> >> wrote:
> >> > Hi all, I swapped from version 1 to version 2.
> >> > I found some information about the configuration file and i wandered
> if
> >> > exist a complete
> >> > list of all the parameters that is possible to set.
> >> >
> >> > Also I have a problem regarding to Wifi devices, after launching:
> >> > olsrd wlan1 eth0 lo
> >> >
> >> > In telnet I tried to obtain information about all the interfaces
> >> > and I'm missing all wlan informations except default hello interval
> and
> >> > vtime (currently connected and pingning a tablet).
> >> >> nhdp interface
> >> > Interface 'eth0': hello_interval=2   hello_vtime=20
> >> >     Address: 147.162.97.20
> >> >     Address: fe80::218:8bff:fe1b:7e59
> >> > Interface 'lo': hello_interval=2   hello_vtime=20
> >> > Interface 'wlan1': hello_interval=2   hello_vtime=20
> >> >
> >> >> Connection closed by foreign host.
> >> >
> >> > the routes command also show me all the eth0 nodes but no one from
> >> > wlan1.
> >> > Somebody had similar problems? Or am I missing something?
> >> >
> >> > Thanks in advance,
> >> > Karoly Szabo
> >> >
> >> > --
> >> > Olsr-dev mailing list
> >> > (spam-protected)
> >> > https://lists.olsr.org/mailman/listinfo/olsr-dev
> >>
> >>
> >>
> >> --
> >> We began as wanderers, and we are wanderers still. We have lingered
> >> long enough on the shores of the cosmic ocean. We are ready at last to
> >> set sail for the stars - Carl Sagan
> >
> >
>
>
>
> --
> We began as wanderers, and we are wanderers still. We have lingered
> long enough on the shores of the cosmic ocean. We are ready at last to
> set sail for the stars - Carl Sagan
>
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://lists.olsr.org/pipermail/olsr-dev/attachments/20131112/76950526/attachment.html>