[Olsr-dev] OLSRv2 configuration and wlan

[Henning Rogge]

Hi,

what IP addresses have you set on eth0, wlan1 and lo before (and
after) you run olsrd2 ?

maybe you can run "ip addr" twice, once before you start the routing
daemon and once 30 seconds afterwards.

Henning Rogge

On Wed, Nov 6, 2013 at 7:56 PM, Karoly Szabo <(spam-protected)> wrote:
> Hi all, I swapped from version 1 to version 2.
> I found some information about the configuration file and i wandered if
> exist a complete
> list of all the parameters that is possible to set.
>
> Also I have a problem regarding to Wifi devices, after launching:
> olsrd wlan1 eth0 lo
>
> In telnet I tried to obtain information about all the interfaces
> and I'm missing all wlan informations except default hello interval and
> vtime (currently connected and pingning a tablet).
>> nhdp interface
> Interface 'eth0': hello_interval=2   hello_vtime=20
>     Address: 147.162.97.20
>     Address: fe80::218:8bff:fe1b:7e59
> Interface 'lo': hello_interval=2   hello_vtime=20
> Interface 'wlan1': hello_interval=2   hello_vtime=20
>
>> Connection closed by foreign host.
>
> the routes command also show me all the eth0 nodes but no one from wlan1.
> Somebody had similar problems? Or am I missing something?
>
> Thanks in advance,
> Karoly Szabo
>
> --
> Olsr-dev mailing list
> (spam-protected)
> https://lists.olsr.org/mailman/listinfo/olsr-dev



-- 
We began as wanderers, and we are wanderers still. We have lingered
long enough on the shores of the cosmic ocean. We are ready at last to
set sail for the stars - Carl Sagan