[Olsr-users] Olsrd cann't ping two-hops node - Nexus7

Henning Rogge (spam-protected)
Tue Nov 5 12:40:45 CET 2013


Good to hear this... :)

Henning

On Tue, Nov 5, 2013 at 12:18 PM, Abubakr Ali <(spam-protected)> wrote:
> Hi Henning Rogge,
>
> I've finally figured out what was the problem. It was simply the "Iptables
> Rules" that were configured, in the Nexus7, to drop all the forwarded
> packets. Now, after adding another rule that enables node2 to forward packet
> that aren't meant to it, the pinging request from node1 to node3 and the
> pinging reply is done through node2 smoothly.
> My next step is to test the network throughput. Therefore, I am building an
> android app as packets-generator, wish me luck ;-)
>
> Thanks
>
>
> Ali, Abubakr
>
>
>
> On 21 October 2013 07:19, Henning Rogge <(spam-protected)>
> wrote:
>>
>> On 10/18/2013 05:05 PM, Abubakr Ali wrote:
>> > Thanks Henning Rogge for your reply ..
>> >
>> > Regards the route from node3 to node1, and at the beginning where all
>> > the three tablets are close to, and in-range of, each others, I see the
>> > following in the //proc/net/route/ :
>> >
>> > Destination==node1
>> > Gateway==node1,
>> > and ...
>> > Destination==node2
>> > Gateway==node2,
>> >
>> > when changing the location of the tablets, then the routes change as
>> > follow:
>> >
>> > Destination==node1
>> > Gateway==node2,
>> > and ...
>> > Destination==node2
>> > Gateway==node2,
>> >
>> > accordingly, this mean that the HELLO and TC msgs are exchanged (i.e.:
>> > the number-of-hops was calculated and that node1 is reachable through
>> > node2), right ?
>>
>> If this is true in both directions on all three nodes, your should be
>> able to ping node3 from node1 (at least from the routing table point of
>> view).
>>
>> You can use tcpdump
>>
>> > you sounded like if the default-values in the .conf file do not do me
>> > any favor and that I have to hard-coded all the default-values myself,
>> > is that true ?
>>
>> The problem with huge config files with lots of "default" values is that
>> its easy to overlook a changed value. I would suggest only adding things
>> to the configuration file that are not using the default value.
>>
>> Henning Rogge
>>
>> --
>> Diplom-Informatiker Henning Rogge , Fraunhofer-Institut für
>> Kommunikation, Informationsverarbeitung und Ergonomie FKIE
>> Kommunikationssysteme (KOM)
>> Fraunhofer Straße 20, 53343 Wachtberg, Germany
>> Telefon +49 228 9435-961,   Fax +49 228 9435 685
>> mailto:(spam-protected) http://www.fkie.fraunhofer.de
>>
>
>
> --
> Olsr-users mailing list
> (spam-protected)
> https://lists.olsr.org/mailman/listinfo/olsr-users



-- 
We began as wanderers, and we are wanderers still. We have lingered
long enough on the shores of the cosmic ocean. We are ready at last to
set sail for the stars - Carl Sagan




More information about the Olsr-users mailing list