[Olsr-users] olsr position update plugin configuration
Fri Nov 23 12:43:30 CET 2012
On 23/11/12 12:40, Ferry Huberts wrote:
> See the pud architecture document at
> and an example config file (with all parameters documented) at
> If you enable the httpinfo plugin as well, then you get a tab with the
> pud position.
> I think the data is also available by means of the jsoninfo plugin but
> I've never used that.
> If after reading these you still have questions, mail again
> On 23/11/12 12:22, Bidur Devkota wrote:
>> Hi All,
>> I was searching for ways to share the position between the nodes in OLSR
>> network. Luckly, I got to know about pud plugin for OLSR. I tried to
>> install it and access the data. Like for dot_draw and txtInfo plugin,
>> we can see the plugin result by monitoring in the assigned
>> port number (in /etc/olsr.conf) . For example 127.0.0.1:2006
>> I am hoping that there should be some similar ways to see the pud plugin
>> data as well. But I did not find any luck. Even searching the web could
>> not link me to some examples showing the way to configure and access pud
>> Are there any special configuration required for pud? It would be of
>> great helo if I can get through some exaples for it.
>> Thanks !
More information about the Olsr-users