[Olsr-users] problem running OLSRD
Markus Kittenberger
(spam-protected)
Wed Feb 1 12:04:03 CET 2012
On Wed, Feb 1, 2012 at 8:10 AM, Teco Boot <(spam-protected)> wrote:
> Your wlan0 is not RUNNING.
>
which is definetely a problem (-;
> It is also not configured in ad hoc mode.
>
which is only a problem if john intends to use olsrd with an adhoc mesh
network (-;
(oslrd itself does not care what wifi settings are used, ...)
Markus
>
> Teco
>
>
> Op 1 feb. 2012, om 07:05 heeft <(spam-protected)> <
> (spam-protected)> het volgende geschreven:
>
> > First... I apologize for the length of this message, just trying to be
> thorough.
> >
> > I have not been able to run OLSRD since I installed it from a debian
> package. I keep getting "No interfaces detected! This might be intentional,
> but it also might mean that your configuration is fubar."
> >
> > S/W:
> > kernel: 3.0.0
> > O/S: Voyage Linux 0.8.0 (10/24/2011 build) (debian 0.6.2 based)
> >
> >
> > H/W
> > SBC: alix.3D3
> > Wlan0: Wistron dnma-92
> > Wlan1: Wistron dnma-92
> > cf: sandisk 4GB
> >
> > output from "olsrd -f /etc/olsrd/olsrd.conf -d 0" command
> > *** olsr.org - 0.6.1-git_-hash_0b616759ced652dc083d7b0cba610180 - ***
> > Build date: 2011-05-07 11:15:38 on newk
> > http://www.olsr.org
> >
> > Parsing file: "/etc/olsrd/olsrd.conf"
> > Debug level: 2
> > IpVersion: 4
> > Noint set to 1
> > TOS: 16
> > Willingness: 7
> > OlsrPort: 698
> > RtTableDefault: 0
> > RtTable: 254
> > Hysteresis disabled
> > Hysteresis Scaling: 0.50
> > Hysteresis UpperThr: 0.80
> > Hysteresis LowerThr: 0.30
> > Pollrate 0.10
> > NIC Changes Pollrate 2.50
> > TC redundancy 2
> > MPR coverage 7
> > Link quality level 2
> > Link quality fish eye 1
> > Clear screen enabled
> > setting ifs_in_curr_cfg = 0
> > Autodetect changes: YES
> > IPv4 broadcast: 10.255.255.255
> > Mode: mesh
> > HELLO interval: 5.00
> > HELLO validity: 90.00
> > TC interval: 3.00
> > TC validity: 300.00
> > MID interval: 15.00
> > MID validity: 270.00
> > HNA interval: 15.00
> > HNA validity: 90.00
> > IPC host: 127.0.0.1
> > IPC net: 10.0.0.0/255.0.0.0
> > HNA IPv4 entry: 10.0.0.0/255.0.0.0
> > Plugin: olsrd_httpinfo.so.0.1
> > Plugin param key:"Port" val: "8080"
> > Plugin param key:"Host" val: "127.0.0.1"
> > Plugin param key:"Net" val: "10.0.0.0 255.0.0.0"
> > Plugin: olsrd_txtinfo.so.0.1
> > Plugin param key:"Accept" val: "127.0.0.1"
> > Plugin param key:"port" val: "8081"
> > Plugin: olsrd_dot_draw.so.0.3
> > Plugin param key:"accept" val: "10.0.1.1"
> > Plugin param key:"port" val: "2004"
> > IPv4 broadcast/multicast : 10.255.255.255
> > Mode : mesh (d)
> > IPv6 multicast : ::
> > HELLO emission/validity : 5.00 (d)/90.00 (d)
> > TC emission/validity : 3.00 (d)/300.00 (d)
> > MID emission/validity : 15.00 (d)/270.00 (d)
> > HNA emission/validity : 15.00 (d)/90.00 (d)
> > Autodetect changes : yes
> > No interfaces detected! This might be intentional, but it also might
> mean that your configuration is fubar.
> > I will continue after 5 seconds...
> > olsr.org - 0.6.1-git_-hash_0b616759ced652dc083d7b0cba610180 -
> detaching from the current process...
> >
> > OLSRD.CONF file
> > DebugLevel 2
> > IpVersion 4
> > AllowNoInt yes
> > TosValue 16
> > Willingness 7
> > OlsrPort 698!
> > RtTableDefault 0
> > RtTable 254
> > UseHysteresis no
> > HystScaling 0.50
> > HystThrHigh 0.80
> > HystThrLow 0.30
> > Pollrate 0.1
> > NicChgsPollInt 2.5
> > TcRedundancy 2
> > MprCoverage 7
> > LinkQualityLevel 2
> > LinkQualityFishEye 1
> > ClearScreen yes
> > #LinkQualityWinSize 100
> > #LinkQualityDijkstraLimit 0 7.0
> >
> > Interface "wlan0" {
> > AutoDetectChanges yes
> > Ip4Broadcast 10.255.255.255
> > Mode "mesh"
> > HelloInterval 5.0
> > HelloValidityTime 90.0
> > TcInterval 3.0
> > TcValidityTime 300.0
> > MidInterval 15.0
> > MidValidityTime 270.0
> > HnaInterval 15.0
> > HnaValidityTime 90.0
> > #LinkQualityMult 192.168.0.1 0.5
> > #LinkQualityMult default 0.8
> > }
> >
> > IpcConnect {
> > MaxConnections 1
> > Host 127.0.0.1
> > Net 10.0.0.0 255.0.0.0
> > }
> >
> > Hna4 {
> > option 'netaddr' '10.0.0.0'
> > option 'netmask' '255.0.0.0'
> > }
> >
> > Hna6 {
> > #:: 0
> > #fec0:2200:106:: 48
> > }
> > LoadPlugin "olsrd_httpinfo.so.0.1" {
> > PlParam "Port" "8080"
> > PlParam "Host" "127.0.0.1"
> > PlParam "Net" "10.0.0.0 255.0.0.0"
> > # PlParam "Net" "0.0.0.0 0.0.0.0"
> > }
> > LoadPlugin "olsrd_txtinfo.so.0.1" {
> > PlParam "Accept" "127.0.0.1"
> > PlParam "port" "8081"
> > }
> > LoadPlugin "olsrd_dot_draw.so.0.3" {
> > PlParam "accept" "10.0.1.1"
> > PlParam "port" "2004"
> > }
> >
> >
> > /etc/network/interfaces file:
> > auto lo
> > iface lo inet loopback
> >
> > auto eth0
> > allow-hotplug eth0
> > iface eth0 inet static
> > address 10.0.1.1
> > netmask 255.0.0.0
> > network 10.0.0.0
> > broadcast 10.255.255.255
> > gateway 10.0.0.1
> >
> > auto wlan0
> > iface wlan0 inet static
> > address 10.0.1.2
> > netmask 255.0.0.0
> > network 10.0.0.0
> > broadcast 10.255.255.255
> > gateway 10.0.0.1
> >
> > auto wlan1
> > iface wlan1 inet static
> > address 10.0.1.3
> > netmask 255.0.0.0
> > network 10.0.0.0
> > broadcast 10.255.255.255
> > gateway 10.0.0.1
> >
> > #auto br0
> > #iface br0 inet static
> > # address 10.0.1.4
> > # netmask 255.0.0.0
> > # network 10.0.0.0
> > # broadcast 10.255.255.255
> > # bridge-ports wlan0 wlan1
> >
> >
> > ifconfig output:
> > eth0 Link encap:Ethernet HWaddr 00:0d:b9:24:96:b4
> > inet addr:10.0.1.1 Bcast:10.255.255.255 Mask:255.0.0.0
> > inet6 addr: fe80::20d:b9ff:fe24:96b4/64 Scope:Link
> > UP BROADCAST RUNNING MULTICAST MTU:1500 Metric:1
> > RX packets:7167 errors:0 dropped:0 overruns:0 frame:0
> > TX packets:5845 errors:0 dropped:0 overruns:0 carrier:0
> > collisions:0 txqueuelen:1000
> > RX bytes:661449 (645.9 KiB) TX bytes:1023549 (999.5 KiB)
> > Interrupt:11 Base address:0x2000
> >
> > lo Link encap:Local Loopback
> > inet addr:127.0.0.1 Mask:255.0.0.0
> > inet6 addr: ::1/128 Scope:Host
> > UP LOOPBACK RUNNING MTU:16436 Metric:1
> > RX packets:18 errors:0 dropped:0 overruns:0 frame:0
> > TX packets:18 errors:0 dropped:0 overruns:0 carrier:0
> > collisions:0 txqueuelen:0
> > RX bytes:1196 (1.1 KiB) TX bytes:1196 (1.1 KiB)
> >
> > mon.wlan1 Link encap:UNSPEC HWaddr
> 00-1B-B1-5D-AE-08-6C-6F-00-00-00-00-00-00-00-00
> > UP BROADCAST RUNNING MULTICAST MTU:1500 Metric:1
> > RX packets:173702 errors:0 dropped:0 overruns:0 frame:0
> > TX packets:0 errors:0 dropped:0 overruns:0 carrier:0
> > collisions:0 txqueuelen:1000
> > RX bytes:31430721 (29.9 MiB) TX bytes:0 (0.0 B)
> >
> > wlan0 Link encap:Ethernet HWaddr 00:1b:b1:5d:ad:98
> > inet addr:10.0.1.2 Bcast:10.255.255.255 Mask:255.0.0.0
> > UP BROADCAST MULTICAST MTU:1500 Metric:1
> > RX packets:0 errors:0 dropped:0 overruns:0 frame:0
> > TX packets:0 errors:0 dropped:0 overruns:0 carrier:0
> > collisions:0 txqueuelen:1000
> > RX bytes:0 (0.0 B) TX bytes:0 (0.0 B)
> >
> > wlan1 Link encap:Ethernet HWaddr 00:1b:b1:5d:ae:08
> > inet addr:10.0.1.3 Bcast:10.255.255.255 Mask:255.0.0.0
> > inet6 addr: fe80::21b:b1ff:fe5d:ae08/64 Scope:Link
> > UP BROADCAST RUNNING MULTICAST MTU:1500 Metric:1
> > RX packets:0 errors:0 dropped:0 overruns:0 frame:0
> > TX packets:6 errors:0 dropped:0 overruns:0 carrier:0
> > collisions:0 txqueuelen:1000
> > RX bytes:0 (0.0 B) TX bytes:576 (576.0 B)
> >
> >
> > finally iwconfig output:
> > lo no wireless extensions.
> >
> > eth0 no wireless extensions.
> >
> > wlan0 IEEE 802.11abgn ESSID:off/any
> > Mode:Managed Access Point: Not-Associated Tx-Power=27 dBm
> > Retry long limit:7 RTS thr:off Fragment thr:off
> > Encryption key:off
> > Power Management:on
> >
> > wlan1 IEEE 802.11abgn Mode:Master Frequency:2.412 GHz Tx-Power=27
> dBm
> > Retry long limit:7 RTS thr:off Fragment thr:off
> > Power Management:on
> >
> > mon.wlan1 IEEE 802.11abgn Mode:Monitor Tx-Power=27 dBm
> > Retry long limit:7 RTS thr:off Fragment thr:off
> > Power Management:on
> >
> > --
> > Olsr-users mailing list
> > (spam-protected)
> > https://lists.olsr.org/mailman/listinfo/olsr-users
>
>
> --
> Olsr-users mailing list
> (spam-protected)
> https://lists.olsr.org/mailman/listinfo/olsr-users
>
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://lists.olsr.org/pipermail/olsr-users/attachments/20120201/58f65aa0/attachment.html>
More information about the Olsr-users
mailing list