[Olsr-users] problem running OLSRD

Teco Boot (spam-protected)
Wed Feb 1 08:10:29 CET 2012


Your wlan0 is not RUNNING.
It is also not configured in ad hoc mode.

Teco


Op 1 feb. 2012, om 07:05 heeft <(spam-protected)> <(spam-protected)> het volgende geschreven:

> First... I apologize for the length of this message, just trying to be thorough.
> 
> I have not been able to run OLSRD since I installed it from a debian package. I keep getting "No interfaces detected! This might be intentional, but it also might mean that your configuration is fubar."
> 
> S/W:
> kernel: 3.0.0
> O/S: Voyage Linux 0.8.0 (10/24/2011 build)  (debian 0.6.2 based)
> 
> 
> H/W
> SBC: alix.3D3
> Wlan0: Wistron dnma-92
> Wlan1: Wistron dnma-92
> cf: sandisk 4GB
> 
> output from "olsrd -f /etc/olsrd/olsrd.conf -d 0" command
>  *** olsr.org -  0.6.1-git_-hash_0b616759ced652dc083d7b0cba610180  - ***
>  Build date: 2011-05-07 11:15:38 on newk
>  http://www.olsr.org
> 
> Parsing file: "/etc/olsrd/olsrd.conf"
> Debug level: 2
> IpVersion: 4
> Noint set to 1
> TOS: 16
> Willingness: 7
> OlsrPort: 698
> RtTableDefault: 0
> RtTable: 254
> Hysteresis disabled
> Hysteresis Scaling: 0.50
> Hysteresis UpperThr: 0.80
> Hysteresis LowerThr: 0.30
> Pollrate 0.10
> NIC Changes Pollrate 2.50
> TC redundancy 2
> MPR coverage 7
> Link quality level 2
> Link quality fish eye 1
> Clear screen enabled
> setting ifs_in_curr_cfg = 0
>         Autodetect changes: YES
>         IPv4 broadcast: 10.255.255.255
>         Mode: mesh
>         HELLO interval: 5.00
>         HELLO validity: 90.00
>         TC interval: 3.00
>         TC validity: 300.00
>         MID interval: 15.00
>         MID validity: 270.00
>         HNA interval: 15.00
>         HNA validity: 90.00
>         IPC host: 127.0.0.1
>         IPC net: 10.0.0.0/255.0.0.0
> HNA IPv4 entry: 10.0.0.0/255.0.0.0
> Plugin: olsrd_httpinfo.so.0.1
> Plugin param key:"Port" val: "8080"
> Plugin param key:"Host" val: "127.0.0.1"
> Plugin param key:"Net" val: "10.0.0.0 255.0.0.0"
> Plugin: olsrd_txtinfo.so.0.1
> Plugin param key:"Accept" val: "127.0.0.1"
> Plugin param key:"port" val: "8081"
> Plugin: olsrd_dot_draw.so.0.3
> Plugin param key:"accept" val: "10.0.1.1"
> Plugin param key:"port" val: "2004"
>         IPv4 broadcast/multicast : 10.255.255.255
>         Mode           : mesh (d)
>         IPv6 multicast           : ::
>         HELLO emission/validity  : 5.00 (d)/90.00 (d)
>         TC emission/validity     : 3.00 (d)/300.00 (d)
>         MID emission/validity    : 15.00 (d)/270.00 (d)
>         HNA emission/validity    : 15.00 (d)/90.00 (d)
>         Autodetect changes       : yes
> No interfaces detected! This might be intentional, but it also might mean that your configuration is fubar.
> I will continue after 5 seconds...
> olsr.org -  0.6.1-git_-hash_0b616759ced652dc083d7b0cba610180  - detaching from the current process...
> 
> OLSRD.CONF file
> DebugLevel 2
> IpVersion 4
> AllowNoInt yes
> TosValue 16
> Willingness 7
> OlsrPort 698!
> RtTableDefault 0
> RtTable 254
> UseHysteresis no
> HystScaling 0.50
> HystThrHigh 0.80
> HystThrLow 0.30
> Pollrate 0.1
> NicChgsPollInt 2.5
> TcRedundancy 2
> MprCoverage 7
> LinkQualityLevel 2
> LinkQualityFishEye 1
> ClearScreen yes
> #LinkQualityWinSize 100
> #LinkQualityDijkstraLimit 0 7.0
> 
> Interface "wlan0" {
>     AutoDetectChanges yes
>     Ip4Broadcast 10.255.255.255
>     Mode "mesh"
>     HelloInterval 5.0
>     HelloValidityTime 90.0
>     TcInterval 3.0
>     TcValidityTime 300.0
>     MidInterval 15.0
>     MidValidityTime 270.0
>     HnaInterval 15.0
>     HnaValidityTime 90.0
>     #LinkQualityMult 192.168.0.1 0.5
>     #LinkQualityMult default 0.8
> }
> 
> IpcConnect {
>     MaxConnections 1
>     Host 127.0.0.1
>     Net 10.0.0.0 255.0.0.0
> }
> 
> Hna4 {
>     option 'netaddr' '10.0.0.0'
>     option 'netmask' '255.0.0.0'
> }
> 
> Hna6 {
>     #:: 0
>     #fec0:2200:106:: 48
> }
> LoadPlugin "olsrd_httpinfo.so.0.1" {
>     PlParam "Port" "8080"
>     PlParam "Host" "127.0.0.1"
>     PlParam "Net" "10.0.0.0 255.0.0.0"
> #    PlParam "Net" "0.0.0.0 0.0.0.0"
> }
> LoadPlugin "olsrd_txtinfo.so.0.1" {
>     PlParam "Accept" "127.0.0.1"
>     PlParam "port" "8081"
> }
> LoadPlugin "olsrd_dot_draw.so.0.3" {
>     PlParam "accept" "10.0.1.1"
>     PlParam "port" "2004"
> }
> 
> 
> /etc/network/interfaces file:
> auto lo
> iface lo inet loopback
> 
> auto eth0
> allow-hotplug eth0
> iface eth0 inet static
>         address 10.0.1.1
>         netmask 255.0.0.0
>         network 10.0.0.0
>         broadcast 10.255.255.255
>         gateway 10.0.0.1
> 
> auto wlan0
> iface wlan0 inet static
>         address 10.0.1.2
>         netmask 255.0.0.0
>         network 10.0.0.0
>         broadcast 10.255.255.255
>         gateway 10.0.0.1
> 
> auto wlan1
> iface wlan1 inet static
>         address 10.0.1.3
>         netmask 255.0.0.0
>         network 10.0.0.0
>         broadcast 10.255.255.255
>         gateway 10.0.0.1
> 
> #auto br0
> #iface br0 inet static
> #       address 10.0.1.4
> #       netmask 255.0.0.0
> #       network 10.0.0.0
> #       broadcast 10.255.255.255
> #       bridge-ports wlan0 wlan1
> 
> 
> ifconfig output:
> eth0      Link encap:Ethernet  HWaddr 00:0d:b9:24:96:b4
>           inet addr:10.0.1.1  Bcast:10.255.255.255  Mask:255.0.0.0
>           inet6 addr: fe80::20d:b9ff:fe24:96b4/64 Scope:Link
>           UP BROADCAST RUNNING MULTICAST  MTU:1500  Metric:1
>           RX packets:7167 errors:0 dropped:0 overruns:0 frame:0
>           TX packets:5845 errors:0 dropped:0 overruns:0 carrier:0
>           collisions:0 txqueuelen:1000
>           RX bytes:661449 (645.9 KiB)  TX bytes:1023549 (999.5 KiB)
>           Interrupt:11 Base address:0x2000
> 
> lo        Link encap:Local Loopback
>           inet addr:127.0.0.1  Mask:255.0.0.0
>           inet6 addr: ::1/128 Scope:Host
>           UP LOOPBACK RUNNING  MTU:16436  Metric:1
>           RX packets:18 errors:0 dropped:0 overruns:0 frame:0
>           TX packets:18 errors:0 dropped:0 overruns:0 carrier:0
>           collisions:0 txqueuelen:0
>           RX bytes:1196 (1.1 KiB)  TX bytes:1196 (1.1 KiB)
> 
> mon.wlan1 Link encap:UNSPEC  HWaddr 00-1B-B1-5D-AE-08-6C-6F-00-00-00-00-00-00-00-00
>           UP BROADCAST RUNNING MULTICAST  MTU:1500  Metric:1
>           RX packets:173702 errors:0 dropped:0 overruns:0 frame:0
>           TX packets:0 errors:0 dropped:0 overruns:0 carrier:0
>           collisions:0 txqueuelen:1000
>           RX bytes:31430721 (29.9 MiB)  TX bytes:0 (0.0 B)
> 
> wlan0     Link encap:Ethernet  HWaddr 00:1b:b1:5d:ad:98
>           inet addr:10.0.1.2  Bcast:10.255.255.255  Mask:255.0.0.0
>           UP BROADCAST MULTICAST  MTU:1500  Metric:1
>           RX packets:0 errors:0 dropped:0 overruns:0 frame:0
>           TX packets:0 errors:0 dropped:0 overruns:0 carrier:0
>           collisions:0 txqueuelen:1000
>           RX bytes:0 (0.0 B)  TX bytes:0 (0.0 B)
> 
> wlan1     Link encap:Ethernet  HWaddr 00:1b:b1:5d:ae:08
>           inet addr:10.0.1.3  Bcast:10.255.255.255  Mask:255.0.0.0
>           inet6 addr: fe80::21b:b1ff:fe5d:ae08/64 Scope:Link
>           UP BROADCAST RUNNING MULTICAST  MTU:1500  Metric:1
>           RX packets:0 errors:0 dropped:0 overruns:0 frame:0
>           TX packets:6 errors:0 dropped:0 overruns:0 carrier:0
>           collisions:0 txqueuelen:1000
>           RX bytes:0 (0.0 B)  TX bytes:576 (576.0 B)
> 
> 
> finally iwconfig output:
> lo        no wireless extensions.
> 
> eth0      no wireless extensions.
> 
> wlan0     IEEE 802.11abgn  ESSID:off/any
>           Mode:Managed  Access Point: Not-Associated   Tx-Power=27 dBm
>           Retry  long limit:7   RTS thr:off   Fragment thr:off
>           Encryption key:off
>           Power Management:on
> 
> wlan1     IEEE 802.11abgn  Mode:Master  Frequency:2.412 GHz  Tx-Power=27 dBm
>           Retry  long limit:7   RTS thr:off   Fragment thr:off
>           Power Management:on
> 
> mon.wlan1  IEEE 802.11abgn  Mode:Monitor  Tx-Power=27 dBm
>           Retry  long limit:7   RTS thr:off   Fragment thr:off
>           Power Management:on
> 
> -- 
> Olsr-users mailing list
> (spam-protected)
> https://lists.olsr.org/mailman/listinfo/olsr-users





More information about the Olsr-users mailing list