[OLSR-users] olsr setup problem

[Sven Wagner]

hi
try this
edit the olsr.conf near line 200
---------------------------------------

# Interfaces and their rules
# Omitted options will be set to the
# default values. Multiple interfaces
# can be specified in the same block
# and multiple blocks can be set.

# !!CHANGE THE INTERFACE LABEL(s) TO MATCH YOUR INTERFACE(s)!!
# (eg. wlan0 or eth1):

Interface "eth1"

---------------------------

on http://212.222.128.110:8080/cfgfile you can see our olsr.conf

maybe that's all

regards
	cven





salsaman wrote:
> Hi,
> my apologies if this is an old issue, but I am newbie to OLSR. I am 
> working with TOSTI Tilburg (http://www.tostitilburg.nl) and we are 
> attempting to set up an OLSR network for the city of Tilburg.
> 
> 
> I have installed OLSR but when I try to run it, I get the following 
> message:
> 
> 
> ---- Interface configuration ----
> 
> eth1:
>        Flags: 00401043
>        Wireless interface detected
>        Could not get address of interface - skipping it
> no interfaces detected!
> 
> 
> 
> 
> The card is a Prism2 PCMCIA card, which is mounted in a cardbus/PCI 
> bridge. The card works fine when connecting to our existing wireless 
> router. Any suggestions as to how to get past this would be welcome.
> 
> Thanks in advance,
> Salsaman.
> 
> _______________________________________________
> olsr-users mailing list
> (spam-protected)
> https://www.olsr.org/mailman/listinfo/olsr-users
>