[OLSR-users] olsrd_0.4.9_arm.ipk

[Andreas Tønnesen]

What does the configuration file look like?

- Andreas

> Hi,
>
> I have install the olsrd 0.4.9 into my ipaq PDA and did an installation.
> The installation was fast but when I start to use the olsrd by typing
> olsrd, the following error message appeared as per below. Can anyone help
> me pls...
>
> Thank you and regards
> Kenny
>
> (spam-protected):~# olsrd
>  *** olsr.org - 0.4.9 ***
>  Build date: Apr  7 2005
>  http://www.olsr.org
> Parsing file: "/etc/olsrd.conf"
> No interfaces detected! This might be intentional, but it also might mean
> that your configuration is fubar.
> I will continue after 5 seconds...
> olsr.org - 0.4.9 detattching from the current process...
> (spam-protected):~# iwconfig eth0
> eth0      IEEE 802.11-DS  ESSID:"manet"  Nickname:"HERMES I"
>           Mode:Ad-Hoc  Frequency:2.412 GHz  Cell: 00:00:00:00:00:00
>           Bit Rate:2 Mb/s   Tx-Power=15 dBm   Sensitivity:1/3
>           Retry limit:4   RTS thr:off   Fragment thr:off
>           Encryption key:off
>           Power Management:off
>           Link Quality:0  Signal level:0  Noise level:0
>           Rx invalid nwid:0  Rx invalid crypt:0  Rx invalid frag:30
>           Tx excessive retries:0  Invalid misc:0   Missed beacon:0
>
> _______________________________________________
> olsr-users mailing list
> (spam-protected)
> https://www.olsr.org/mailman/listinfo/olsr-users
>


---------
Andreas Tønnesen
http://www.olsr.org