[Olsr-users] ignore whether interface is wireless

[Adam Longwill]

Can't you just set the olsr mode for the interface to "ethernet" and that
takes care of it? By default it's wireless.

On Tue, May 2, 2017 at 4:43 PM, Lonnie Nunweiler <(spam-protected)
> wrote:

> Is it possible to setup olsr to treat a wireless interface as if it were
> an Ethernet?  All I want is for an easy to gather routing table and NOT
> worry about wireless quality, etc.
>
> I have tried to set  LinkQualityLevel   0 but then it just stops doing
> everything.
>
> What I desire is that if it gets anything into a device it will examine
> and use that info to see if there should be a route taken from it.
>
> Also, I want to be able to have duplicate paths and not end up in a loop.
>
> Lonnie Nunweiler
>
>
> --
> Olsr-users mailing list
> (spam-protected)
> https://lists.olsr.org/mailman/listinfo/olsr-users
>
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://lists.olsr.org/pipermail/olsr-users/attachments/20170502/14f1c0d7/attachment.html>