[Olsr-users] olsr2 and multipath

[Ansgar Jazdzewski]

Hi,

i am try to setup a new smal datacenter and we like to test olsr2 as
the layer3-dataplane.

wath i have done so far is:

bring all my NICs up with a IPv4 link-local and set a host ip on loopback.
olsr is running so far, but i can not see any multipah in my routing-table

####
(spam-protected):/home/sprd# ip rout show
default via 172.16.162.1 dev eno2  proto 100  src 172.16.162.167
metric 2 onlink
default dev eno2  scope link  metric 1003
169.254.0.0/16 dev eno2  proto kernel  scope link  src 169.254.8.60
169.254.0.0/16 dev eno1  proto kernel  scope link  src 169.254.8.55
172.16.162.1 via 172.16.162.1 dev eno2  proto 100  src 172.16.162.167
metric 2 onlink
172.16.162.156 via 169.254.22.61 dev eno2  proto 100  src
172.16.162.167  metric 2 onlink
172.16.162.161 via 169.254.12.73 dev eno2  proto 100  src
172.16.162.167  metric 2 onlink
172.16.162.178 via 169.254.9.132 dev eno2  proto 100  src
172.16.162.167  metric 2 onlink
####
(spam-protected):/home/sprd# ip -4 addr show dev lo
1: lo: <LOOPBACK,UP,LOWER_UP> mtu 65536 qdisc noqueue state UNKNOWN
group default qlen 1
   inet 127.0.0.1/8 scope host lo
      valid_lft forever preferred_lft forever
   inet 172.16.162.168/32 scope global lo
      valid_lft forever preferred_lft forever
   inet 172.16.162.167/32 scope global lo
      valid_lft forever preferred_lft forever
####

so my questions are:
how can i configure it, or is multipath no possible with olsr2?

Tanks
Ansgar