[Olsr-users] Changes in v0.12.0 ?

[Henning Rogge]

On Thu, Jun 30, 2016 at 9:14 PM, Henning Rogge <(spam-protected)> wrote:
> On Thu, Jun 30, 2016 at 9:05 PM, Lars Kruse <(spam-protected)> wrote:
>> I am sorry for the confusion: both configuration files refer to _different_
>> nodes.
>> To summarize it: we have a dozen openwrt-based routers. They are all running
>> with olsrd2 v0.11.7. Their (uci) configuration files are auto-generated and
>> look similar to the one I attached.
>>
>> Additionally there is a debian based server. The (non-uci) config file belongs
>> to it.
>> We used to run v0.11.7 on this server - this worked fine.
>> Then we switched to v0.12 (only on this server, no configuration file change) -
>> this triggered the behaviour described by Martin.
>
> So you used the "olsrd2-0_12_1.conf" file also with the 0.11.7
> version... I think we are getting closer to a potential solution.
>
> Just for testing, could you remove the "ifname loopback" line from the
> config file and see if it changes anything? The rest of the config
> looks quite normal (assuming that "tap-mesh" is your only mesh
> interface).

Hi...

I think I just found (after a quite long debugging session) the
problem with your IPv6 network...

You might want to have a look at the v0.12.2 tag.

Henning