[Olsr-users] Mesh on Gondola

[Hesameddin Alizadeh]

I changed the TCInterval values because I am going to decrease a bit the overhead but the other values are still in default. 
I am not using different Interface which MID is not important and do not set any HOST or NETWORK to the HNA.( Maybe is better to comment both of them?!)
Actually the topology are changing every 30 seconds. Do you think that does not need to change on setting ?   

-----Original Message-----
From: Henning Rogge [mailto:(spam-protected)] 
Sent: Mittwoch, 16. Dezember 2015 17:08
To: Hesameddin Alizadeh <(spam-protected)>
Cc: (spam-protected)
Subject: Re: [Olsr-users] Mesh on Gondola

On Wed, Dec 16, 2015 at 4:52 PM, Hesameddin Alizadeh <(spam-protected)> wrote:
> I assigned new value for TC Interval which is :
>
> HelloInterval       2.0
> HelloValidityTime   20.0
> TcInterval          32.0
> TcValidityTime      300.0
> MidInterval         5.0
> MidValidityTime     300.0
> HnaInterval         5.0
> HnaValidityTime     300.0

Could you please STOP setting values to parameters you don't understand?

Either use the defaults OR read carefully (with the knowledge you got up to this point) through all the emails again.

I am pretty sure nobody suggested increasing TC interval a lot and keeping MID/HNA interval short.

Henning