[Olsr-users] Link/hop costs for OLSR

[Michel Blais]

You can increse or decrease link cost with LinkQualityMult.

 From olsrd.conf.default.full :

     # If a certain route should be preferred
     # or ignored by the mesh, the Link Quality
     # value of a node can be multiplied with a factor
     # entered here. In the example the route
     # using 192.168.0.1 would rather be ignored.
     # A multiplier of 0.5 will result in a small
     # (bad) LinkQuality value and a high (bad)
     # ETX value.
     # Note:
     # Link quality multiplier is used only when
     # LinkQualityLevel is > 0.

     # example 1: reduce LQ to 192.168.0.1 by half
     # LinkQualityMult 192.168.0.1 0.5

     # example 2: reduce LQ to all nodes on this interface by 20%
     # LinkQualityMult default 0.8

Le 2011-11-04 17:46, Ros Molodyko a écrit :
> Hi All,
>
> is any "cost" parameter I can set in the OLSR configuration to send traffic through the preferred OLSR links or routers?
>
> I tried the "Weight" one, but it looks like obsolete and does not make any effect.
>
> Thank you,
> Ros Molodyko
> Mayflower Communications
>
-- 
Michel Blais
Administrateur réseau / Network administrator
Targo Communications
www.targo.ca
514-448-0773