[OLSR-users] OLSR IPV6, Add route : address family not supported by protocol

[andrew p]

Hi all,

Before describing the situation, Id like to thank you for carrying on
reading and take a
look on my posting.

I am making a testbed for OLSR IPV6 now and found an information in OLSRD
log file
that says "add route : address family not supported by protocol".

The question is : does this message indicate that OLSR have not work
properly yet?

Configuration that I am working on is 3 nodes with all nodes having the same
prefix,
mean they are in the same link before OLSR is being run.
Thus able to ping each other before and after OLSR start running.

olsrd.conf content for all three nodes are the same :

DEBUG        1
IPVERSION    6
INTERFACES    eth1 (this one depends on the device interface)
ALLOW_NO_INT    yes
IP4BROAD    auto
IP6ADDRTYPE    global
IP6MULTI-SITE    auto
IP6MULTI-GLOBAL    auto
POLLRATE    auto
HELLOINT    auto
HELLOMULTI    auto
TCINT        auto
TCMULTI        auto
NWHELLOINT    auto
NWHELLOMULTI    auto
MIDINT        auto
MIDMULTI    auto
HNAINT        auto
HNAMULTI    auto
TOSVALUE    auto
WILLINGNESS        auto
PC-CONNECT        no
USE_HYSTERESIS    yes
HYST_SCALING    auto
HYST_THR_HIGH    auto
HYST_THR_LOW    auto
TC_REDUNDANCY    auto
MPR_COVERAGE    auto


Regards,
Andrew P
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://lists.olsr.org/pipermail/olsr-users/attachments/20070308/5c25e9bb/attachment.html>