[OLSR-users] recovery from broken link

[Bing]

Hi Andreas,

Thank you for your quick reply. My config file (olsrd.conf) is the default, 
that is, almost everything is commented except LQ is on as follows:
UseHysteresis no
Link quality level 2
LinkQualityWinsize 10

In Interface part, only two options:
HelloInterval 0.2
HelloValidityTime 5.0

My command is : olsrd -d 2

Thanks.

Bing

----- Original Message ----- 
From: "Andreas Tønnesen" <(spam-protected)>
To: "OLSR discussion and development" <(spam-protected)>
Sent: Tuesday, November 29, 2005 2:13 PM
Subject: Re: [OLSR-users] recovery from broken link


> Hi Bing,
>
> That is some strange behaviour... Could you test using 0.4.9 or
> better yet, current CVS?
> Also the configuration used is needed. Please post the config file/command 
> line options.
>
> Thanks.
>
> - Andreas
>
> Bing wrote:
>> Hello all,
>>  I am testing olsrd 4.8. I wanted to test node moving in and out of the 
>> network.
>> For movement out of the area, I  simply powered off that node. It seemed 
>> olsrd could never recover by itself. OLSRD in the other nodes also 
>> stopped working. After over 20 minutes, I had to manually stop olsrd by 
>> "Ctrl C", and restart olsrd.   For movement in, it was good, olsrd could 
>> automatically detect the new node without affecting other nodes.
>> What's wrong with this? Is the way it is or some bugs?
>>  Thanks.
>>  Bing
>>
>>
>> ------------------------------------------------------------------------
>>
>> _______________________________________________
>> olsr-users mailing list
>> (spam-protected)
>> https://www.olsr.org/mailman/listinfo/olsr-users
>
>
> _______________________________________________
> olsr-users mailing list
> (spam-protected)
> https://www.olsr.org/mailman/listinfo/olsr-users