[OLSR-users] Trying to connect PC to Freifunk OLSR network
Alex Harford
(spam-protected)
Sun Apr 17 01:57:47 CEST 2005
I have 2 WRT54g's running the Freifunk firmware, and I'm stuck trying
to get my PC to connect. It was previously able to when the WRT was
acting as an AP.
The olsr network is using the 2.0.0.0 network, my specific nodes are
in 2.129.50.0
First I'd like to confirm that it can work on combined 802.11b and g
networks. If so, read on. :)
Here is the relevent information from the internet connected WRT:
(spam-protected):~/etc# route
Kernel IP routing table
Destination Gateway Genmask Flags Metric Ref Use Iface
2.129.50.2 * 255.255.255.255 UH 1 0 0 eth1
192.168.1.0 * 255.255.255.0 U 0 0 0 br0
154.20.0.0 * 255.255.192.0 U 0 0 0 vlan1
2.0.0.0 * 255.0.0.0 U 0 0 0 eth1
default 154.20.0.254 0.0.0.0 UG 0 0 0 vlan1
(spam-protected):~/etc# iwconfig eth1
eth1 IEEE 802.11-DSF ESSID:"olsr.bcwireless.net"
Mode:Ad-Hoc Channel:1 Cell: 42:76:79:C8:92:87
Bit Rate:48Mb/s Tx-Power=15 dBm
Retry limit:0 RTS thr:off Fragment thr:off
Encryption key:off
Link Quality:5/5 Signal level:-56 dBm Noise level:-256 dBm
Rx invalid nwid:0 Rx invalid crypt:0 Rx invalid frag:0
Tx excessive retries:0 Invalid misc:0 Missed beacon:0
(spam-protected):~/etc# ifconfig eth1
eth1 Link encap:Ethernet HWaddr 00:0F:66:36:87:FF
inet addr:2.129.50.1 Bcast:2.255.255.255 Mask:255.0.0.0
UP BROADCAST RUNNING MULTICAST MTU:1500 Metric:1
RX packets:18555 errors:0 dropped:0 overruns:0 frame:8273
TX packets:20585 errors:3 dropped:0 overruns:0 carrier:0
collisions:0 txqueuelen:100
RX bytes:2455570 (2.3 MiB) TX bytes:3975983 (3.7 MiB)
Interrupt:4 Base address:0x1000
-------------------------------------------------------------------------
And here is the PC:
[(spam-protected) ~]# route
Kernel IP routing table
Destination Gateway Genmask Flags Metric Ref Use Iface
192.168.1.0 * 255.255.255.0 U 0 0 0 eth0
2.0.0.0 * 255.0.0.0 U 0 0 0 eth1
default yam 0.0.0.0 UG 0 0 0 eth0
[(spam-protected) ~]# iwconfig eth1
eth1 IEEE 802.11-DS ESSID:"olsr.bcwireless.net"
Nickname:"ebi.bchsia.telus.net"
Mode:Ad-Hoc Frequency:2.412GHz Cell: 42:76:79:C8:92:87
Bit Rate=11Mb/s Tx-Power=15 dBm Sensitivity:1/3
Retry min limit:8 RTS thr:off Fragment thr:off
Encryption key:off
Power Management:off
Link Quality:0 Signal level:0 Noise level:0
Rx invalid nwid:0 Rx invalid crypt:1 Rx invalid frag:0
Tx excessive retries:0 Invalid misc:0 Missed beacon:0
[(spam-protected) ~]# ifconfig eth1
eth1 Link encap:Ethernet HWaddr 00:30:BD:60:E3:04
inet addr:2.129.50.3 Bcast:2.255.255.255 Mask:255.0.0.0
inet6 addr: fe80::230:bdff:fe60:e304/64 Scope:Link
UP BROADCAST RUNNING MULTICAST MTU:1500 Metric:1
RX packets:2612 errors:0 dropped:0 overruns:0 frame:0
TX packets:434 errors:344 dropped:0 overruns:0 carrier:0
collisions:0 txqueuelen:1000
RX bytes:182228 (177.9 KiB) TX bytes:50798 (49.6 KiB)
Interrupt:11 Base address:0x100
when I run olsrd on the PC, I get the following messages:
*** olsr.org - 0.4.8 ***
Build date: Apr 16 2005
http://www.olsr.org
Parsing file: "/etc/olsrd.conf"
*** olsrd configuration ***
Debug Level : 9
IpVersion : 4
No interfaces : ALLOWED
TOS : 0x10
Willingness : AUTO
IPC connections : 0
Host 127.0.0.1
Pollrate : 1.00
TC redundancy : 0
MPR coverage : 1
LQ level : 0
LQ window size : 10
Clear screen : no
Interfaces:
dev: "eth1"
IPv4 broadcast : AUTO
IPv6 addrtype : site-local
IPv6 multicast site/glbl : ff05::15/ff0e::1
HELLO emission/validity : 2.00/6.00
TC emission/validity : 5.00/15.00
MID emission/validity : 5.00/15.00
HNA emission/validity : 5.00/15.00
Using hysteresis:
Scaling : 0.50
Thr high/low : 0.80/0.30
IP forwarding is enabled on this system
Initializing parser...
Parser: registering event for type 1
Register parse function: Added function for type 1
Parser: registering event for type 2
Register parse function: Added function for type 2
Parser: registering event for type 3
Register parse function: Added function for type 3
Parser: registering event for type 4
Register parse function: Added function for type 4
Scheduler event registered int: 20.00
Initializing APM
APM info:
AC status 0
Battery percentage 1077149696%
Could not read APM info - setting default willingness(3)
Using IP version 4
---- Interface configuration ----
Checking eth1:
Wireless interface detected
MTU: 1500
Index 167854376
Address:2.129.50.3
Netmask:255.0.0.0
Broadcast address:2.255.255.255
Binding socket 5 to device eth1
Adding OLSR socket entry 5
New main address: 2.129.50.3
Scheduler event registered int: 2.00
Scheduler event registered int: 5.00
Scheduler event registered int: 5.00
Scheduler event registered int: 5.00
Scheduler event registered int: 5.00
Initializing duplicatetable - hashsize 32
Scheduler event registered int: 2.00
TC: init topo
MPRS: Init
MID: init
Scheduler event registered int: 1.00
Scheduler event registered int: 1.00
Loading plugins...
Main address: 2.129.50.3
Scheduler started - polling every 1.00 seconds
Max jitter is 0.500000
Building HELLO on interface 0
Unknown type: 202, size 28, from 2.129.50.2
Unknown type: 201, size 32, from 2.129.50.2
Unknown type: 202, size 28, from 2.129.50.1
Building HELLO on interface 0
Unknown type: 201, size 32, from 2.129.50.1
Unknown type: 201, size 32, from 2.129.50.2
Building HELLO on interface 0
Unknown type: 202, size 28, from 2.129.50.2
Received HNA from NON SYM neighbor 2.129.50.1
Building HELLO on interface 0
Unknown type: 201, size 32, from 2.129.50.1
Unknown type: 201, size 32, from 2.129.50.2
Building HELLO on interface 0
Unknown type: 202, size 28, from 2.129.50.1
Unknown type: 202, size 28, from 2.129.50.2
Unknown type: 201, size 32, from 2.129.50.2
Building HELLO on interface 0
Unknown type: 201, size 32, from 2.129.50.1
Building HELLO on interface 0
Unknown type: 201, size 32, from 2.129.50.2
Unknown type: 202, size 28, from 2.129.50.1
Building HELLO on interface 0
Unknown type: 201, size 32, from 2.129.50.1
Unknown type: 202, size 28, from 2.129.50.2
Unknown type: 201, size 32, from 2.129.50.2
Building HELLO on interface 0
Unknown type: 201, size 32, from 2.129.50.1
Any suggestions?
Thanks,
Alex
More information about the Olsr-users
mailing list