[OLSR-users] olsrd on multiple interfaces

[Pawel Foremski]

Hi!

I'm running olsrd 0.4.7 on Linksys WRT-54G with OpenWRT firmware. I've got 5 
interfaces on it (1 x wireless, 4 x Ethernet) I'd like to run olsrd on: eth0, 
vlan1, vlan2, vlan3 and vlan4. The IP addresses are the same on each 
interface.

I'm trying to deploy the following scenario: there are 3 machines, 10.1.0.1 
(pc), 10.3.0.1 (wrt54g nr 2) and 10.2.0.1 (wrt54g) between them (the one I'm 
currently fighting with :P). All of the machines are running olsrd 0.4.7. I'd 
like to make 10.1.0.1 be able to communicate via 10.2.0.1 with 10.3.0.1, 
simple. But the olsrd daemon running at 10.2.0.1 on multiple interfaces seems 
to add all discovered routes only on the first interface from "INTERFACES" 
list. In my setup the list is "vlan1 eth1 vlan2 vlan3 vlan4".

10.3.0.1, which I'm trying to contact from 10.1.0.1, is connected to eth1; 
10.1.0.1 is connected to vlan1. So, olsrd running on 10.2.0.1 properly adds 
the route to 10.1.0.1 (vlan1), but fails to add proper route to 10.3.0.1 
(eth1), using vlan1 instead. Of course I can't contact 10.3.0.1 from 
10.1.0.1.

And here is my question - is it a bug, am I missing something obvious or is it 
a "feature" :P?

Thanks in advance for your reply.

-- 
Pawel Foremski
(spam-protected)
http://pjf.dotgeek.org/