[Olsr-dev] olsrd + bmf plugin

[Erik Tromp]

Hi Vincent,

Could you try to ping to 224.0.0.1 ? You should receive an answer from all
your nodes, like this:

(spam-protected):~# ping 224.0.0.1
PING 224.0.0.1 (224.0.0.1) 56(84) bytes of data.
64 bytes from 192.168.151.50: icmp_seq=1 ttl=64 time=0.511 ms
64 bytes from 192.168.151.53: icmp_seq=1 ttl=64 time=4.67 ms (DUP!)
64 bytes from 192.168.151.55: icmp_seq=1 ttl=63 time=10.7 ms (DUP!)
64 bytes from 192.168.151.50: icmp_seq=2 ttl=64 time=0.076 ms
64 bytes from 192.168.151.53: icmp_seq=2 ttl=64 time=1.23 ms (DUP!)
64 bytes from 192.168.151.55: icmp_seq=2 ttl=63 time=1.23 ms (DUP!)
. . .

(your IP addresses will of course be different)

Does that work? Could you send the output?

--Erik 


-----Oorspronkelijk bericht-----
Van: (spam-protected)
[mailto:(spam-protected)] Namens Vincent Nuttin
Verzonden: dinsdag 15 maart 2011 21:36
Aan: (spam-protected)
Onderwerp: [Olsr-dev] olsrd + bmf plugin

Hi all !

I'm running the version 0.6.0 of olsrd on multiple Neo FreeRunner...
The "basics" of olsrd run fine; I mean, olsrd builds a network topology and
so on. I can "ping" any device from all of them...
everything is fine.

Then, I want to use broadcast messages. I read in the documentation that the
BMF plugin is fine for that. I installed it on my devices but, it does not
forward anything... The best example is the one with three devices :
"N1" can see "N2". "N2" can see "N3" but "N1" and "N3" have no direct route
to each other (i.e they must use "N2" in the middle). When "N1"
sends a broadcast UDP packet to 10.255.255.255, I want "N2" to receive it
(this part is OK ;-) and I also want "N2" to forward it to "N3"...

My olsrd.conf file is here :
http://www.geosharing-project.org/files/public/olsrd.conf

Do you have any idea ?
Thanks a lot,

Vincent

--
Olsr-dev mailing list
(spam-protected)
http://lists.olsr.org/mailman/listinfo/olsr-dev